MikroTik Config Builder

Fill in one form per router and get one script that sets it up: ISP uplinks, PPPoE server, pool, plan speeds, NAT, protection, backup and isolation.

The name shown in WinBox and the clock.

Router name (identity)

Time zone

Time servers (NTP)

The lines from your ISPs. The lowest distance is the main line; the others take over when it is down.

The ports where the OLT or switches connect. They are joined in one bridge; the PPPoE server runs on it (or on a VLAN).

Subscriber ports

Separate with commas.

VLAN ID (optional)

Bridge name

PPPoE service name

MTU / MRU

One session per modem

The IP addresses the subscribers get. Each router needs its own range.

Pool name

Gateway (local address)

Range

DNS servers

One profile per plan, with the plan's upload / download speed.

Make the plan profiles

Burst (150% for a short time)

Use them as this router's Router + Plan mapping when saving

	Plan	PPP profile	Speed (up / down)

Internet sharing (NAT masquerade on the ISP side)

Router answers DNS for subscribers

Basic protection (drop traffic from the ISP side, turn off telnet / ftp / web)

Only allow WinBox, SSH and API from management networks

SNMP for monitoring (read only)

Community

Daily backup on the router at

Isolation rules for unpaid subscribers (from Isolation Templates)

Choose a router.

Download the script (or Copy). The ISP password is only in the downloaded script.
In WinBox open New Terminal and paste it, or upload the .rsc file in Files and run /import file-name=onekonek-config-....rsc.
Then connect the router to ONE-KONEK in Router Setup (API user, tunnel, RADIUS).